Os/2 (Monitormouse) - Advantech FPM-40T User Manual

A.5 OS/2 (MonitorMouse)
BEFORE YOU BEGIN
First be sure OS/2 is installed and operating properly with your
mouse. As you will be modifying the CONFIG.SYS file, it is best to
have the OS/2 installation disks or a bootable DOS disk readily
available. This way, any problems in CONFIG.SYS which cause the
system not to boot can be corrected by rebooting from the disk(s).
Five steps are required when installing MonitorMouse for OS/2:
Step 1 - Configure your Controller
Step 2 - Copy the Software
Step 3 - Modify CONFIG.SYS
Step 4 - Install the Touchscreen Control Panel
Step 5 - Calibrate the Touchscreen
STEP 1 - CONFIGURE YOUR CONTROLLER
Verify your controller configuration. Elo typically ships touchscreen
controllers preconfigured for use with Elo software, including
MonitorMouse for OS/2. Configuration requires setting switches and/
or installing jumpers that determine controller operating parameters.
You will need these parameters when you install the MonitorMouse
for OS/2 driver software. For controller installation instructions, refer
to the IntelliTouch Product Manual or the AccuTouch Product
Manual.
Appendix A Touchscreen Driver Installation
23