Table of Contents
Advertisement
Sending a Test Email Message
To use this function, the Mail Event Log must be enabled and properly set up.
To sent a test message:
1.
Go to the Main Window.
See "Opening the Main Window" on page 19.
2.
Click the DAS Management icon and click the Mail Setting button.
3.
Click the Verify Mail button.
A test message is sent to the designated receiver address.
Upgrading the Firmware
Follow this procedure to upgrade the firmware on your SmartStor.
Downloading the Firmware Upgrade File
To download the upgrade file:
1.
Point your browser to http://www.promise.com.
The firmware was placed in "Support" > "Download" > "DS4600"
2.
Download the DS4600 firmware upgrade file to your PC.
The firmware upgrade filename will be similar to ds4600_xxxxxx_xx.upg
Installing the Firmware Upgrade File
To install the firmware upgrade file:
1.
Go to the Main Window.
See "Opening the Main Window" on page 19.
2.
Click the DAS Management icon and click the Upgrade Firmware button.
3.
Click the folder
4.
Click the folder icon, navigate to the firmware upgrade file, click the file, and
click the Open button.
The path and firmware upgrade file appear in the field.
5.
Click the Upgrade button.
The upgrade takes about two or three minutes.
6.
In the Upgrade Success popup message, click the OK button.
Do not disconnect the power or shut down the SmartStor while the
upgrade is running!
icon.
Warning
33
Chapter 3: SmartNAVI
Advertisement
Table of Contents
