2.3) Rollers Not Running
CAUSES
1. No power to the unit.
2. Emergency switch is engaged.
3. Disengaged Paper Guide switch.
4. Opened safety cover.
5.Opened Front Table Switch.
6. Film is jammed on the rollers.
7. Disconnected motor wire.
8. Blown motor fuse.
9. Defective main motor.
10. Defective main PCB.
MEASURES
1. No power to the unit.
a. Make sure the power plug is connected to the proper source of outlet
(220V, 15Amp, & single phase).
2. Emergency switch is engaged.
a. Disengage the emergency switches located on the front and on the rear of the machine
by rotating the knob clock-wise.
3. Disengaged Paper Guide switch.
a. Properly position the paper guide to engage the switch.
Front Left
Paper Guide
Rear Left
7