5
OPERATING BASICS
Switching The Power On/Off
Press the selector knob once to switch on the transceiver while
switch off, Press and hold it for 3 seconds to switch off while standby.
Adjusting The Volume
After switch on the transceiver, press the selector knob once, When
LCD displays "SET VOLUME XX" (XX shows for current volume
level), turn the channel selector knob to adjust volume, Clockwise-
up, anticlockwise-down.
Switching The Working Mode
Press
key or Microphone
V/M
VFO mode and channel mode.
10
Note: Unavailable while in channel number mode.
Selector Knob Adjusting Frequency/Channel
Under frequency mode, you can change the current frequency to
the desired one through selector knob; Turn clockwise to increase
frequency; turn anticlockwise to decrease. Every gear will increase
or decrease one step.
Note:
5k, 6.25k, 10k, 12.5k, 20k, 25k, 30k, 50k total eight step size
available for this transceiver.
Under channel mode, Turn selector knob clockwise to forward
channel, counterclockwise to backward channel.
key while standby to switch between
In relevant modes ,the Microphone [UP/DWON] key have the same
function of adjusting frequency or edited channel.(this transceiver
shows only edited channels).
Squelch Off / Squelch Off Momentary
key can be set as "Squelch Off / Squelch Off Momentary"
SQ/C
function. This function enable you to monitor weak signal.
12
Squelch off: Press
key once to disable squelch, background
SQ/C
noise appears. Press
SQ/C
22
Squelch Off Momentary: Press and hold
squelch, background noise appears. Release
squelch.
Note:
The above functions should be set in software,
return key while in function setups.
Receiving
The green LED lamp flashes when the channel being called. then
you can hear the calling from the transmitting party.
Note:
If the transceiver has set with higher squelch level, it may fail to hear
the calling.
If the green lamp keep lighting, it means the transceiver is receiving a
matching carrier and un-matching signaling. The calling is not audible.
( Please refer to signaling combination setup).
key again to resume squelch.
key to disable
SQ/C
key to resume
SQ/C
key become a
SQ/C