Insert New Waypoint - Leica MX400 Operating Instructions Manual

Operator's Manual
6. When you have found the waypoint you want, press the Insert
This WPT softkey.
7. When you are finished, press the Done softkey to get back to the
main menu.
8. You can then choose to select another waypoint using the same
method, select Escape to go back one level and use another
method to enter waypoints, or select Done do go back to the
main menu.
9. Don't forget to press the E key to end your editing.

Insert New Waypoint

The following example assumes RTE1 is empty. Follow the
directions in the Erasing An Existing Route section to start with an
empty route if you have waypoints in the RTE1 screen.
1. Select the RTE key until the RTE1 screen is displayed.
2. Press the E key to enter the edit mode.
3. Select Insert from the display. Skip to the next step if RTE1 is
empty.
4. Select Insert New Waypoint from the display.
40
Route
Version 3.3