Log Pulses - Gps Sog Log Pulse Output; Mx 480 - Mx 480 Pc Chart Interface Control - Leica MX400 Operating Instructions Manual

Configuration

Log Pulses - GPS SOG Log Pulse Output

This screen controls the output port (Pulse) of the speed over
ground log output from the receiver at a userdefined pulse rate per
nautical mile. This output is normally used to feed GPS SOG to the
ARPA. The default state is that the speed log is not active, and set
to 200 pulses per nautical mile. Refer to the Installation & Service
Manual for the hardware interface from one of the NMEA output
ports.
Activate the output by selecting Yes to Emulation Enable, select the
appropriate hardware port, and set the pulse rate - based on the
device that you are connecting to.

MX 480 - MX 480 PC Chart Interface Control

The MX400 Series GPS receiver can be interfaced with MX 480
personal computer based electronic charting software program.
When the MX 480 mode is enabled, the chart program assumes the
following functions of the receiver: Active Route Creation,
Waypoint Library, and Tides. The personal computer must be
connected to the RS-232 port of Port 2 on the receiver (refer to the
Installation & Service Manual, Programming Cable diagram).
Version 3.3
Operator's Manual
131