Yamaha CDR1000 Owner's Manual page 58

All-track Sync Recording
This section explains how to use All-track Sync Recording.
The following illustration shows the procedure for All-track Sync Recording.
Track Number
or Start ID
Recording starts
SYNC
REC
(SYNC-REC ALL)
Prepare for recording, as explained on page 32, setting the input source to
1
COAX, but instead of proceeding to the Recording section, proceed as fol-
lows.
From stop, press the [SYNC REC] button.
2
Record Standby mode is engaged, "SYNC-REC 1" appears on the display, the PAUSE
indicator lights up, and the REC indicators flash. If the loaded disc is a blank disc, track
1 is selected for recording. If it's a partially recorded disc, the next available track is
selected.
Use the [PREV] and [NEXT] button to select All-track Sync Recording mode.
3
"SYNC-REC ALL" appears on the display.
You can cancel All-track Sync Recording at anytime by pressing the [STOP] button.
The LOCK indicator should appear, indicating that the CDR1000 is wordclock locked
to the incoming digital signal. Sync Recording is not possible if the LOCK indicator
does not light up or is flashing. See "Selecting the Input Source" on page 33 for more
information.
In Record Standby mode, the selected input source can be monitored via the ANALOG
OUT, AES/EBU OUT, COAXIAL OUT, or PHONES, and metered on the CDR1000
level meters.
Discs can be finalized automatically when Sync Recording is stopped, using the Auto
Finalize function. Press the [SYNC REC] button while Record Standby mode is
engaged to turn on the Auto Finalize function. "AUTOFINALIZE" appears on the dis-
play. Press again to cancel Auto Finalize. See page 53 for more information on finalizing
discs.
Prepare the source CD, DAT, or MD player so that it's ready to start playback.
4
Always record tracks in their normal order, and do not use programmed playback,
which may cause track numbers to be written incorrectly. Use One-track Sync Record-
ing to track one track at a time if you want to change the track order.
The CDR1000 will start recording when it receives a Track Number or Start ID. CD or
MD players must be stopped or paused at the top of the track to be recorded, as Sync
Recording cannot be started while the source device is playing.
Synchronized Recording from CD, DAT, or MD
Track Number
or Start ID
Tn=1 Tn=2
Track Number
or Start ID
Tn=3
CDR1000—Owner's Manual
51
End of source
Recording stops