Using a Footswitch
An optional footswitch, such as the Yamaha FC5, can be connected to the FOOT SW
jack and used to stop and start playback and recording. Footswitch operation depends
on the current mode, as shown in the following table.
Current Mode
Stop
Playback
Record Standby
Recording
1. Tracks can be selected using the [PREV] and [NEXT] buttons before starting playback.
2. Footswitch operation is ignored when using Sync Recording.
Disabling the Remote Controller
The remote controller can be disabled using the Utility Remote parameter, thereby pre-
venting accidental operation.
Use the [UTILITY] button to select "REMOTE."
1
The UTILITY indicator lights up and the Remote setting appears on the display.
Use the [PREV] and [NEXT] buttons to select either "ON" or "OFF."
2
Setting
ON (default)
OFF
Press and hold the [UTILITY] button, or press another button to cancel Utility.
3
Playback starts from the selected track number.
Playback stops.
2
Recording starts.
2
Recording stops.
The remote controller operates as normal.
Commands transmitted by the remote controller are ignored.
Using a Footswitch
Footswitch Operation
Description
CDR1000—Owner's Manual
59
1