Ip Filter - LevelOne WHG-1000 User Manual

4.6.2

IP Filter

The administrator can setting IP Filter via this page, Please click on Advance → IP Filter and follow the below
setting.

Source Address/Mask : Enter the desired source IP address and netmask; the mask must be a plain number,
i.e. 192.168.100.10/32

Source Port : The source port(s) required for this rule. A single port may be given, or a range may be given as
start:end , which will match all ports from start to end, inclusive.

Destination Address/Mask : Enter the desired destination IP address and netmask; the mask must be a plain
number, i.e. 192.168.1.10/32

Destination Port : The destination port(s) required for this rule. A single port may be given, or a range may be
given as start:end , which will match all ports from start to end, inclusive.

In/Out : This option used for specialized packet alteration. The system support In (INPUT : for packets coming
into the interface itself) or Out (FORWARD : for altering packets being routed through the interface)

Protocol : This option allows you to select protocol type. The system support TCP, UDP or ICMP.

Listen : Enable Yes to match TCP packets only with the SYN flag.

Policy : Enter Deny to DROP specialized packet; Pass to ACCET the specialized packet

Interface : Select specified interface where filtering of the incoming /passing-through packets is processed
 Schedule : Select specified time period for this rule.
Click Save button to add IP filter rule to List. There are 20 rules maximum allowed in this IP Filter List. All rules can
be edited or removed on the List. Click Reboot button to activate your changes.
WHG-1000 300Mbps Wireless PoE Hotspot Gateway
109
User's Manual