LevelOne WHG-1000 User Manual page 28

 Service : By default, it's "Disable". To "Enable" to activate this function.
 IP Address To Ping : specify an IP address of the target host which will be monitored
 Ping Interval : specify time interval (in seconds) between the ICMP "echo requests" are sent. Default is 60
seconds.
 Startup Delay : specify initial time delay (in seconds) until first ICMP "echo requests" are sent. The value of
Startup Delay should be at least 60 seconds as the network interface and wireless connection initialization
takes considerable amount of time if the device is rebooted. Default is 60 seconds.
 Failure Count : specify the number of ICMP "echo response" replies. If the specified number of ICMP
"echo response" packets is not received continuously, the primary WAN traffic will be routed secondary
WAN.
If Connection Detect is disabled on "Load Balance" or "Backup", the system will use default value.
if "Connection Detection" is disabled and the PHY's connection status shows Red(Status → Port Link
Info). the system will detect PHY on every 5 seconds. When system detect failure 1 times, the traffic of
package will routed via Secondary WAN Interface. When Primary WAN Interface detect 1 time success,
the traffic of package will routed via Primary WAN Interface.
If "Connection Detection" is disabled and the PHY's connection is Green(Status → Port Link Info), the
system will detect remote Gateway IP address of Primary WAN on every 5 seconds. When system detect
failure 3 times, the traffic of package will routed via Secondary WAN Interface. When Primary WAN
Interface detect 1 time success, the traffic of package will routed via Primary WAN Interface.
Change these settings as described here and click Save button to save your changes. Click Reboot button to
activate your changes
WHG-1000 300Mbps Wireless PoE Hotspot Gateway
28
User's Manual