Table of Contents
Advertisement
Controls System
Maintenance
Adjusting the Accelerator
Pedal
1. Position the vehicle on a level surface, stop the
engine, and engage the parking brake.
2. Adjust the ball joint on the accelerator cable
(Figure 72) to allow 0.200 to 0.350 inch (5 to 8.9 mm)
of clearance between the accelerator pedal arm and
the top of the diamond tread floor plate (Figure 72),
when a 20 lb (9 kg) force is applied to the center of
the pedal. Tighten the locknut.
Note: The engine must not be running and the
return spring must be attached.
WARNING
The governor is preset at the factory to a
maximum engine speed of 3650 rpm. If the
speed is not correct, refer to the Workman
Service Manual or contact your authorized Toro
Dealer/Distributor for assistance.
Figure 72
1. Accelerator cable
2. Ball joint
1. 0.200 to 0.350 inch (5 to 8.9 mm) clearance
Adjusting the Clutch Pedal
Service Interval: Every 200 hours
Note: You can adjust the clutch pedal cable at the bell
housing or at the clutch pedal pivot. The front hood can
be removed to ease the access to pedal pivot.
1. Loosen the jam nuts securing the clutch cable to the
bracket on the bell housing (Figure 74).
1. Clutch cable
2. Jam nuts
Note: You may remove and rotate the ball joint, if
additional adjustment is required.
2. Disconnect the return spring from the clutch lever.
3. Adjust the jam nuts or ball joint until the back, rear
edge of the clutch pedal is 3.75 ± 0.12 inch (9.5 ± 0.3
cm) from the top of the floor plate diamond pattern,
when an 4 lb (1.8 kg) force is applied to the pedal
(Figure 75).
53
Figure 73
Figure 74
3. Return spring
4. Ball joint
Hide quick links:
Advertisement
Table of Contents
