Hour Meter; Fuel Gauge; Light Switch; Oil Pressure Warning Light - Toro 07367 Operator's Manual

Hour Meter

Indicates the total hours of machine operation. The
hour meter (Figure 10) starts to function whenever the
key switch is rotated to the On position or if the engine
is running.
3rd High Lockout Switch
Move the 3rd high lockout switch (Figure 10) to the slow
position and remove the key to prevent the use of third
gear when in the High range. The engine will shut off
if the shift lever is moved to third gear when in High
range. The key is removable in either position.

Light Switch

Push the light switch (Figure 10) to toggle the headlights
on or off.

Oil Pressure Warning Light

The oil pressure warning light glows (Figure 10) if the
engine oil pressure drops below a safe level while the
engine is running. If the light flickers or remains on,
stop the vehicle, turn off the engine, and check the oil
level. If the oil level was low, but adding oil does not
cause the light to go out when the engine is restarted,
turn the engine off immediately and contact your local
Toro distributor for assistance.
Check the operation of warning lights as follows:
1. Apply the parking brake.
2. Turn the ignition key to the On position, but do not
start the engine. The oil pressure light should glow
red. If the light does not function, either a bulb is
burned out or there is a malfunction in the system
which must be repaired.
Note: If engine was just turned off, it may take 1 to 2
minutes for the light to come on.
Coolant Temperature Gauge and Light
Registers the coolant temperature in the engine.
Operates only when the ignition switch is in On position
(Figure 10). The indicator light will illuminate blinking
red if the engine overheats.
Charge Indicator
Illuminates when battery is being discharged. If light
illuminates during operation, stop vehicle, turn off
engine and check for possible causes, such as alternator
belt (Figure 10).
Important: If alternator belt is loose or broken, do
not operate the vehicle until adjustment or repair is
complete. Failure to observe this precaution may
result in damage to the engine.
Check the operation of warning lights as follows:
• Apply parking brake.
• Turn the ignition key to the On position, but do not
start the engine. The coolant temperature, charge
indicator, and oil pressure lights should glow. If any
light does not function, either a bulb is burned out
or there is a malfunction in the system which must
be repaired.

Fuel Gauge

The fuel gauge shows the amount of fuel in the tank. It
operates only when ignition switch is in the On position
(Figure 10). Red indicates low fuel level and blinking
red indicates near empty.
High Flow Hydraulics Switch (TC
models only)
Turn on the switch to activate the high flow hydraulics
(Figure 10).
Horn Button (TC models only)
Pressing the horn button activates the horn (Figure 10).
Tachometer
Registers the RPM of the engine (Figure 10 & Figure 11).
White triangle indicates desired RPM for PTO operation
(Figure 11).
1. RPM of the engine
18
Figure 11
2. 3300 RPM for 540 RPM
PTO operation