Engine Maintenance; Inspecting The Carbon Canister Air Filter; Servicing The Air Cleaner; Changing The Engine Oil And Filter - Toro 07367 Operator's Manual

Engine Maintenance

Inspecting the Carbon Canister
Air Filter
Service Interval: After the first 50 hours
Every 200 hours
1. Locate the air filter on the bottom of the carbon
canister (Figure 45).
1
Figure 45
1. Filter opening
2. Ensure that the opening on the bottom of the filter
is clear and open.

Servicing the Air Cleaner

Service Interval: Every 200 hours—Change the air
cleaner filter. (more frequently in
dusty or dirty conditions)
Inspect the air cleaner and hoses periodically to maintain
maximum engine protection and to ensure maximum
service life. Check the air cleaner body for damage which
could possibly cause an air leak. Replace a damaged air
cleaner body.
Inspect and change the air cleaner filter as described in
the following procedure:
1. Pull the latch outward and rotate the air cleaner
cover counterclockwise.
1. Air cleaner cover
2. Before removing the filter, use low pressure
3. Remove and replace the primary filter.
G016089
4. Inspect the new filter for shipping damage, checking
5. Insert the new filter by applying pressure to the outer
6. Clean the dirt ejection port located in the removable
7. Install the cover orienting the rubber outlet valve in
8. Secure the cover latches. Reset the indicator if it is
Changing the Engine Oil And
Filter
Service Interval: After the first 50 hours
42
Figure 46
air (40 psi, clean and dry) to help remove large
accumulations of debris packed between the outside
of the primary filter and the canister.
Important: Avoid using high pressure air which
could force dirt through the filter into the intake
tract. This cleaning process prevents debris
from migrating into the intake when the primary
filter is removed.
Note: Cleaning of the used element is not
recommended due to the possibility of damage to
the filter media.
the sealing end of the filter and the body.
Important: Do not use a damaged element.
rim of the element to seat it in the canister.
cover. Remove the rubber outlet valve from the
cover, clean the cavity, and replace the outlet valve.
a downward position—between approximately 5:00
to 7:00 when viewed from the end.
showing red (if so equipped).
2. Filter