Heavy Duty Operation; Premaintenance Procedures; Using The Bed Safety Support - Toro 07367 Operator's Manual

Heavy Duty Operation

Important: If the vehicle is subjected to any of the conditions listed below, maintenance should be
performed twice as frequently:
• Desert operation
• Cold climate operation below 32 degrees F (0 degrees C)
• Trailer towing
• Frequent operation on dusty roads
• Construction work
• After extended operation in mud, sand, water, or similar dirty conditions, have your brakes inspected and cleaned
as soon as possible. This will prevent any abrasive material from causing excessive wear.
Premaintenance
Procedures
Many of the subjects covered in this maintenance section
require raising and lowering the bed. The following
precautions must be taken or serious injury or death
could result.
WARNING
Before servicing or making adjustments to the
machine, stop engine, set parking brake, and
remove key from the ignition switch. Remove any
load material from the bed or other attachment
before working under a raised bed. Never work
under a raised bed without positioning the safety
support on a fully extended cylinder rod.

Using the Bed Safety Support

Important: Always install or remove the bed
support from the outside of the bed.
1. Raise the bed until the lift cylinders are fully
extended.
2. Remove the bed support from the storage brackets
on back of the ROPS panel (Figure 32).
1. Bed support
3. Push the bed support onto the cylinder rod, making
sure the support end tabs rest on the end of cylinder
barrel and on the cylinder rod end (Figure 33).
36
Figure 32