Electrical System Maintenance; Fuses; Jump Starting The Vehicle - Toro 07367 Operator's Manual

Electrical System
Maintenance

Fuses

The fuses for the machine's electrical system are located
under the center of the dash panel (Figure 51 and
Figure 52).
Figure 51
1. Fuses
Figure 52

Jump Starting the Vehicle

WARNING
Jump starting can be dangerous. To avoid personal
injury or damage to electrical components in
vehicle, observe the following warnings:
• Never jump start with a voltage source greater
than 15 volts D.C. This will damage the electrical
system.
• Never attempt to jump start a discharged battery
that is frozen. It could rupture or explode during
jump starting.
• Observe all battery warnings while jump starting
your vehicle.
• Be sure your vehicle is not touching the jump
start vehicle.
• Connecting cables to the wrong post could
result in personal injury and/or damage to the
electrical system.
1. Squeeze the battery cover to release the tabs from
battery base. Remove the battery cover from the
battery base (Figure 53).
1. Battery cover
2. Connect a jumper cable between the positive posts of
the two batteries (Figure 54). The positive post may
be identified by a + sign on top of the battery cover.
3. Connect one end of the other jumper cable to the
negative terminal of the battery in the other vehicle.
The negative terminal has NEG on the battery cover.
Do not connect the other end of the jumper cable to
the negative post of the discharged battery. Connect
it to the engine or frame. Do not connect the jumper
cable to the fuel system.
45
Figure 53