Specifications; Attachments/Accessories; Operation; Checking The Engine Oil Level - Toro 07367 Operator's Manual

Specifications

Note: Specifications and design are subject to change
without notice.
Dimensions
Overall Width 63 inches (160 cm)
w/o bed: 128.25 inches (326 cm)
w/full bed: 130.38 inches (331 cm)
Overall Length
w/2/3 bed in rear mounting location:
136.38 inches (346 cm)
Model 07366—1623 lb (736 kg)
Model 07367—1951 lb (885 kg)
Model 07367TC—2032 lb (921.6 kg)
Base Weight (Dry)
Model 07370—2010 lb (912 kg)
Model 07370TC—2091 lb (948 kg)
Rated Capacity Model 07366—3227 lb (1464 kg)
(includes 200 lb. Model 07367—2899 lb (1315 kg)
operator, 200 lb. Model 07367TC—2818 lb (1278 kg)
passenger and loaded Model 07370—2840 lb (1288 kg)
attachment). Model 07370TC—2759 lb (1251 kg)
Maximum. Gross 4,850 lb (2200 kg)
Vehicle Weight
Tow Capacity Tongue weight 600 lb (272 kg)
Maximum trailer weight 3,500 lb (1587
kg)
Ground Clearance 7 inches (18 cm) w/ no load
Wheel Base 70 inches (118 cm)
Wheel Tread (center Front: 46 inches (117 cm)
line to center line) Rear: 47.7 inches (121 cm)
Height 75 inches (190.5 cm) to top of ROPS

Attachments/Accessories

A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.

Operation

Note: Determine the left and right sides of the
machine from the normal operating position.
CAUTION
Before servicing or making adjustments to the
machine, stop the engine, set the parking brake,
and remove the key from the switch. Remove any
load material from the bed or other attachment
before working under a raised bed. Never work
under a raised bed without positioning the safety
support on a fully extended cylinder rod.

Checking the Engine Oil Level

Service Interval: Before each use or daily
The engine is shipped with approximately 3.5 quarts
(3.3 l) (w/ filter) of oil in the crankcase; however, you
should check the oil level before and after the engine
is first started.
Note: The best time to check the engine oil is when
the engine is cool before it has been started for the
day. If it has already been run, allow the oil to drain
back down to the sump for at least 10 minutes before
checking. If the oil level is at or below the Add mark
on the dipstick, add oil to bring the oil level to the Full
mark. Do not overfill. If the oil level is between the
Full and Add marks, no additional oil is required.
The engine uses any high-quality 10W-30 detergent oil
having the American Petroleum Institute (API) service
classification SJ, SK, SL, SM, or higher. Choose a
viscosity according to the table in Figure 14.
1. Position the machine on a level surface.
2. Remove the dipstick (Figure 15)and wipe it with a
clean rag. Insert the dipstick into the tube and make
sure it is seated fully. Remove dipstick and check
the level of the oil.
20
G016095
Figure 14