Converting The Speedometer - Toro 07367 Operator's Manual

1. Clutch pedal
Note: Force is applied so the clutch release bearing
lightly contacts the pressure plate fingers.
4. Tighten the jam nuts after the adjustment has been
attained.
5. Recheck the 3.75 ± 0.12 inch (9.5 ± 0.3 cm)
dimension after the jam nuts have been tightened to
ensure proper adjustment. Readjust, if necessary.
6. Connect the return spring to the clutch lever.
Important: Ensure that the rod end is
positioned squarely on the ball, not twisted, and
remains parallel to the clutch pedal after the jam
nut is tightened (Figure 76).
1. Clutch cable rod end
2. Clutch pedal
Note: The clutch free play should never be less than
0.75 inch (19 mm).
Figure 75
2. 3.75 ± 0.12 inch (9.5 ± 0.3
cm)
Figure 76
3. Rod end jam nut
4. Parallel

Converting the Speedometer

You can convert the speedometer from MPH to KPH
or KPH to MPH.
1. Position the vehicle on a level surface, stop the
engine, engage the parking brake, and remove the
key from the ignition switch.
2. Remove the hood. Refer to Removing the Hood in
the Pre-maintenance Procedures.
3. Locate the two loose wires next to the speedometer.
4. Remove the connector plug from the harness wire
and connect the wires together.
The speedometer will switch to KPM or MPH.
5. Install the hood.
54