Table of Contents
Advertisement
Back to Contents Page
Dell™ OptiPlex™ GX520 User's Guide
I/O Panel
I/O Panel
Removing the I/O Panel
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
NOTE:
Note the routing of all cables before disconnecting them, so that you can re route them correctly when installing the new I/O panel.
1. Follow the procedures in
"Before You
2. Remove the cable from the I/O panel by pulling on the pull-loop.
3. Remove the screw that secures the I/O panel to the desktop computer.
NOTICE:
When sliding the I/O panel out of the computer, be extremely careful. Carelessness may result in damage to the cable connectors and the
cable routing clips.
4. Gently rotate and slide the I/O panel away from the computer.
1
securing screw
2
I/O panel
3
I/O cable connector
4
I/O connector pull-loop
Replacing the I/O Panel
1. To replace the I/O panel, follow the removal procedures in the reverse order.
NOTE:
Use the guides on the I/O panel bracket to help position the I/O panel in place and use the notch on the I/O panel bracket to help seat the card.
Back to Contents Page
Begin."
Advertisement
Table of Contents
