Do not pull the drive out of the computer by the drive cables. Doing so may cause damage to cables and the cable connectors.
5. Lift the drive out of the computer and disconnect the power and hard-drive cables from the drive.
1 securing tabs (2)
2 hard drive
6. Disconnect the power and hard-drive cable from the drive.
1 power cable
2 serial ATA data cable
Installing a Hard Drive
1. Check the documentation for the drive to verify that it is configured for your computer.
NOTICE:
To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as a foam pad, that will sufficiently
cushion it.
2. Unpack the replacement hard drive, and prepare it for installation.
3. If your replacement hard drive does not have the plastic drive bracket attached, remove the bracket from the existing drive by unsnapping it from the