Table of Contents
Advertisement
1 fully seated card
2 not fully seated card
3 bracket within slot
4 bracket caught outside of slot
8. If applicable, before replacing the card retention mechanism, ensure that:
The tops of all cards and filler brackets are flush with the alignment bar.
l
The notch in the top of the card or filler bracket fits around the alignment guide.
l
9. Snap the card retention mechanism into place, securing the card(s) in the computer.
NOTICE:
Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer cover from closing properly or
cause damage to the equipment.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
10. Connect any cables that should be attached to the card.
See the documentation for the card for information about the card's cable connections.
11.
Replace the computer
cover.
12. If you installed a sound card:
a. Enter
System
Setup, select Audio Controller, and change the setting to Off.
b. Connect external audio devices to the sound card's connectors. Do not connect external audio devices to the microphone, speaker/headphone,
or line-in connectors on the back panel.
13. If you installed an network adapter card and want to turn off the integrated network adapter:
a.
Enter system
setup, select Network Controller, and change the setting to Off.
b. Connect the network cable to the network adapter card's connectors. Do not connect the network cable to the integrated network connector on
the back panel of the computer.
14. Install any drivers required for the card as described in the card documentation.
Removing a PCI Card
1. Follow the procedures in
"Before You
2. Gently push the release tab on the card retention latch from the inside to pivot the latch open. Because the latch is captive, it will remain in the open
position.
3. Use the card retention mechanism to secure the card in place from the top:
a. Place your thumb on the top of the card retention mechanism and grip the bottom of the retention mechanism with your fingers.
b. With your free hand, gently squeeze the sides of the card retention mechanism to release it from the tab slots holding it in place.
c. Pivot the card retention mechanism upward to release it from the two tab slots.
d. Set the card retention mechanism aside in your work area.
Begin."
Advertisement
Table of Contents
