Table of Contents
Advertisement
8. Attach the serial ATA connector removed in
9. Locate an unused serial ATA connector on the system board and attach a drive cable to this connector and to the second hard drive.
1 hard-drive cable
2 hard-drive cable on system board
3 power cable
10.
Replace the computer
cover.
Drive-Panel Inserts
If you are installing a new floppy or CD/DVD drive instead of replacing a drive, remove the drive-panel inserts.
1. Follow the procedures in
"Before You
2. Remove the drive panel by sliding the drive release latch downward to open the panel. Then remove it from the hinges.
step 5
to the first hard drive.
Begin."
Advertisement
Table of Contents
