Table of Contents
Advertisement
1. Unpack the replacement hard drive, and prepare it for installation.
2. Check the documentation for the drive to verify that it is configured for your computer.
NOTE:
If your replacement hard drive does not have the plastic hard-drive bracket attached, remove the bracket from the existing drive by unsnapping
it from the drive. Snap the bracket onto the new drive.
1 hard drive
2 hard-drive bracket
1 hard drive
2 hard-drive bracket
3. Gently slide the hard drive into the hard-drive bracket until it clicks into place.
4. Gently slide the hard drive into the drive bay until it clicks into place.
5. Connect the power and hard-drive cables to the drive. Connect the hard-drive cable to the connector on the system board.
6. Check all connectors to be certain that they are properly cabled and firmly seated.
Advertisement
Table of Contents
