Power Connector Cable - HP Spectre x360 Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation,
turn the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
a. Remove the battery (see
b. Remove the fan (see
c. Remove the system board (see
d. Remove the display assembly (see
Remove the power connector cable:
1. Release the power connector cable (1) from the retention clips built into the bottom cover.
2. Remove the Phillips PM2.0×4.1 screw (2) that secures the power connector to the top cover.
3. Remove the power connector cable (3).
Reverse this procedure to install the power connector cable.
Bottom cover on page
Battery on page 25).
Fan on page 29).
System board on page
Display assembly on page
24), and then remove the following components:
33).
40).
Power connector cable
Spare part number
801513-001
43