Card Reader Board - HP Spectre x360 Maintenance And Service Manual

3. Remove the TouchPad and cable.
Reverse this procedure to install the TouchPad.

Card reader board

Description
Card reader board (includes cable)
Before removing the card reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation,
turn the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the speakers (see
Remove the card reader board:
1. Release the ZIF connector (1) to which the card reader board cable is attached, and then
disconnect the card reader board cable from the system board.
2. Remove the Phillips PM2.0×2.7 screws (2) that secure the card reader board to the top cover.
32 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 25).
Speakers on page 30).
24).
Spare part number
801498-001