Ignition Failure; Low Igniter Current - State Water Heaters SUF 130 300 Instruction Manual

FAULT AND ALERT MESSAGES
in your area.
POSSIBLE CAUSES - CHECK/REPAIR
NOTE:
see Venting Installation on page 21.
Start Up on page 50.
Table 4 on page 13.
Supply Gas Regulator on page 13.
Operation on page 54 for minimum igniter amp requirements.
NOTE:
in the Heater Information menu - see Heater Information on page
see Venting Requirements on page 22.
DISPLAYED FAULT/ALERT MESSAGE
AC Reversed
Power supply to water heater
has reversed polarity.
Call a service professional:
Your Company Name Here
(press [DOWN] for more....)
CHANGE

Ignition Failure

The water heater has failed to
ignite the burner.
Call a service professional:
Your Company Name Here
(press [DOWN] for more....)
CHANGE
Low Gas Pressure
The supply gas pressure to the
water heater is low.
Call a service professional:
Your Company Name Here
(press [DOWN] for more....)
CHANGE

Low Igniter Current

Igniter current is low.
Call a service professional:
Your Company Name Here
(press [DOWN] for more....)
CHANGE
Blocked Exhaust
The exhaust is blocked or
restricted. Ensure
condensate hose is draining.
Call a service professional:
Your Company Name Here
(press [DOWN] for more....)
CHANGE
58
Fault occurred 2 mins ago
BACK ADVANCED
Fault occurred 2 mins ago
ADVANCED
BACK
Fault occurred 2 mins ago
BACK ADVANCED
Fault occurred 2 mins ago
BACK ADVANCED
Fault occurred 2 mins ago
BACK ADVANCED