Fault And Alert Conditions - State Water Heaters SUF 130 300 Instruction Manual

valve leaking or open.
WATER IS TOO HOT
Operating Set Point is set too high. See Operating Set Point
NOISY OPERATION
WATER LEAKAGE IS SUSPECTED
NOTE:
Systems on page 14. The Temperature-Pressure Relief Valve is
REPLACEMENT PARTS

FAULT AND ALERT CONDITIONS

FAULT CONDITIONS
ALERT CONDITIONS
RESETTING CONTROL SYSTEM LOCK OUTS
DIAGNOSTIC CHECKS
NOTE:
Jumping out control circuits or components can
result in property damage, personal injury or death.
Service should only be performed by a qualified service
agent using proper test equipment.
Altering the water heater controls and/or wiring in any way
could result in permanent damage to the controls or water
heater and is not covered under the limited warranty.
Altering the water heater controls and/or wiring in any way
could result in altering the ignition sequence allowing gas to
flow to the main burner before the hot surface igniter is at
ignition temperature causing delayed ignition which can
cause a fire or explosion.
Any bypass or alteration of the water
heater controls and/or wiring will result
in voiding the appliance warranty.
57
Electrical Shock Hazard
Turn off power to the water heater
before performing any service.
Label all wires prior to disconnecting
when performing service. Wiring errors
can cause improper and dangerous
operation.
Verify proper operation after servicing.
Failure to follow these instructions can
result in personal injury or death.