Tools Needed; Items Not Included - Mighty Mule 500 UL325 SERIES Installation Manual

Drill
Level
Clamp
• Low voltage wire will be needed to run from the
transformer to the control box; length depends
upon the distance between the transformer power
supply and the control box. See Transformer Wiring
Installation on page 20, and the accessory catalog.
• PVC conduit.
• If your gate is more than 1000' away from an ac
power source you will need to use at least one
Mighty Mule® 5 watt solar panel to trickle charge
the battery. See the accessory catalog (Do not use
both transformer and solar).
• If you have thin walled tube or panel gates, see
Recommended Reinforcement Examples in "Quick
Reference Guide" after Step 3 of "Mounting Opener
to Gate" section.
Before You Begin

Tools Needed

3/8" Bit
5/16" Bit
Pliers
Hack Saw
9/16"
wrench
x2

Items Not Included

Pen
1/2"
wrench
Philips Head
Screwdriver
Adjustable
Wrench
• Depending on the type of gate, a horizontal cross
member or mounting plate may be needed to mount
the front of the opener and gate bracket to the gate.
See Gate Bracket Mounting Examples in "Quick
Reference Guide" after Step 3 of "Mounting Opener
to Gate" section.
• Surge protection for transformer.
• Some types of installations require u-bolts.
• If the gate is a push-to-open refer to page 16 in
Installation Manual.
• Additional washers or a metal plate may be needed
for wooden post.
• Outlet in weatherproof cover.
• Strain relief nuts for accessory devices.
• If post is more than 6", bolts longer than 8" are
needed.
12
Center
Punch
Hammer
Flat Head
Screwdriver
Wire
Small
Stripper
Flat Head
Tape
Measure