Receiver Installation; Gate Stop Installation - Mighty Mule 500 UL325 SERIES Installation Manual

Control Box Installation
FCC Regulation
This device complies with FCC rules Part 15.
Operation is subject to the following conditions:
1. This device may not cause harmful interference.
2. This device must accept an interference that
may cause undesired operation.
Transmitter distance may vary due to circumstances
beyond our control. NOTE: The manufacturer is
not responsible for any radio or TV interference
caused by unauthorized modifications to
this equipment. Such modifications could
void the user's authority to operate
the equipment.
2
W
Check Receiver/Remote signal reception in mounted position/OK—
secure Receiver in position to fence or post. NOTE: If mounting
on metal fence, mount receiver on a piece of wood. Mounting the
receiver on metal can cause intereference and the receiver may not
work properly. DO NOT mount upside down.
1
Fully open gate. Attach gate stop with one of the following:
• U-bolts—tube and chain link gates (Not included)
• Wood/lag screws—flat aluminum/wood supports (Not included).
Do not tighten.

Receiver Installation

W

Gate Stop Installation

J
1
'
1 0
x
M a
Install Receiver within 10 ft of control box (longer lengths avail-
able - call us). NOTE: NEVER splice receiver cable. DO NOT
run cable through metal conduit because the receiver signal
range will decrease. DO NOT run cable through conduit contain-
ing AC wire. DO NOT place receiver within 3 feet of AC power.
1. Mount the receiver high and above any obstructions; fence
pickets, column caps, etc.
2. If radio control seems limited try moving the receiver 1-2 feet
in each direction to reduce radio noise "dead spots".
2
1
Position gate stop with gate CLOSED to fence post. Tighten
fasteners. Cut off excess bolt length.
22
Tips
1