Setting Obstruction Stall Force And Auto Close Time; Setting Your Personal Code - Mighty Mule 500 UL325 SERIES Installation Manual

Setting Obstruction Stall Force & Auto Close Time
1
Turn the "STALL FORCE" arrow in the center of the potentiom-
eter with small flat head screwdriver. Adjust the sensitivity from the
MINIMUM position up to the point where the gate operates without
obstructing from its own weight or the wind conditions in your area.
IMPORTANT: For safety reasons the obstructions setting or Stall Force on the Mighty Mule®
control board comes from the factory set at MIN (minimum). In many installations this setting
will need to be adjusted to overcome the weight and size of the gates.
ALWAYS KEEP SAFETY AT THE TOP OF YOUR LIST WHEN ADJUSTING OR SERVICING YOUR
Setting Personal Transmitter Code
All GTO transmitters are set to a standard code at the factory and are ready to operate your GTO PRO® Gate Opener
For your safety and security, however, we strongly recommend that you replace the factory setting with your own personal code.
Follow the directions below:
1
Remove back cover of the opener remote.
Control Box Settings
AUTOMATIC GATE OPENER
2
Turn the "AUTO CLOSE TIME" arrow in the center of the potenti-
ometer with small flat head screwdriver. Turning the pot all the way
counter-clockwise will turn the auto close feature off. The minimum
auto close time is 3 seconds.The maximum (turn the pot all the way
clockwise) auto close time is 120 seconds.
2
1 2 3 4 5 6 7 8 9
Flip opener remote over. Use small screwdriver to move switch-
es to random positions. If you have more than one transmitter,
now is a good time to set them all with the same code.
28
.
®