Table of Contents
Advertisement
ToolS AnD PARTS
Gather the required tools and parts before starting installation.
Tools needed:
Flat-blade screwdriver
Wire stripper (direct wire
installations)
1/4" nut driver
(recommended)
Adjustable wrench that
opens to 1" (25mm) or
hex-head socket wrench
Tape measure
Level
INSTALLATION REQUIREMENTS
#2 Phillips screwdriver
Tin snips (new vent
installations)
Vent clamps
Utility knife
Pliers
Caulking gun and
compound (for installing
new exhaust vent)
Parts supplied (all models):
Leveling legs (4)
Parts supplied (steam models):
"Y" connector
Long inlet hose
Parts package is located in dryer drum. Check that all parts
are included.
noTE: If installing dryer on pedestal, do not use leveling legs.
optional Equipment: (Not supplied with dryer)
Refer to your Use and Care Guide for information about
accessories available for your dryer.
Parts needed:
(Not supplied with dryer)
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Check code requirements. Some codes limit, or do not permit,
installing dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
Short inlet hose
Rubber washer
3
Hide quick links:
Advertisement
Table of Contents
