Installation Requirements; Tools And Parts - Maytag WGD4915EW2 Installation Instructions Manual

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation.
Tools needed for all installations:
Flat-blade screwdriver
1/4" nut driver or socket
wrench (recommended)
Tape measure
Level
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Utility knife
Wire Stripper (direct wire
installations)
4
#2 Phillips screwdriver
Tin snips (new vent
installations)
Vent clamps
Pliers
Caulking gun and
compound (for installing
new exhaust vent)
Putty knife
Tools needed for gas installations:
8" (203 mm) or 10"
(254 mm) pipe wrench
Pipe-joint compound
resistant to LP gas
Parts supplied (all models):
Leveling legs (4)
(Length and appearance of legs may vary according to model)
Parts supplied (steam models):
"Y" connector
Short inlet hose
Parts package is located in dryer drum. Check that all parts
are included.
Parts needed (steam models):
5' (1.52 m) inlet hose
If using a power supply cord:
Use a UL listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
A UL listed 30-amp power supply cord, rated 120/240 volt
■
minimum. The cord should be type SRD or SRDT and be
at least 4 ft. (1.22 m) long. The wires that connect to
the dryer must end in ring terminals or spade terminals
with upturned ends.
A UL listed strain relief.
■
8" (203 mm) or 10"
(254 mm) adjustable wrench
(for gas connections)
or
Rubber washer