General Information; Initial Start−Up; Applicability; Operating And Service Documents - Viessmann VITOFLAME 200 Service Instructions Manual

General Information

Safety instructions
Please follow these safety instructions closely to prevent accidents and material losses.
Work on the equipment
Installation, initial start−up,
maintenance and repairs must only
be carried out by a competent
person (heating engineers/
installation contractors) (EN 50 110,
part 1, and VDE 1000, part 10, or
local regulations).
Before working on the equipment/
heating system, isolate the mains
electrical supply (e. g. by removing a
separate mains fuse or by means of
a mains electrical isolator) and
safeguard against unauthorised
reconnection.
Disconnection must be carried out
by means of an isolating device
which simultaneously isolates all
non−earthed conductors with at least
3 mm contact separation.
Work requiring the control unit to be
opened must not subject internal
components to electrostatic
discharges.

Applicability

Operating and service documents

1. Complete and separate the
customer registration card:
H Hand the system user section
to the user for safekeeping.
H Keep the heating engineer
portion.
2
Repair work
It is not permitted to carry out
repairs on parts that fulfil a safety
function.
Use only original Viessmann spare
parts or equivalent which have been
approved by Viessmann.
Initial start−up
This must be carried out by the
system installer or a commissioning
engineer designated by him; all
actual values should be recorded in a
commissioning/service report.
Applicable to burners from serial no.:
7159805 2 00001 kkk,
7159806 2 00001 kkk,
7159807 2 00001 kkk,
7159808 2 00001 kkk,
7159809 2 00001 kkk,
7159810 2 00001 kkk,
7159811 2 00001 kkk,
7159812 2 00001 kkk
2. File all parts lists, operating and
service instructions in the folder
and hand over to the system user.
Instructing the system user
The system installer must hand the
operating instructions to the system
user and instruct him/her in the
operation of the system.
This symbol is a reference
to other instructions which
must be observed.