Viessmann VITOFLAME 200 Service Instructions Manual page 17

Burner control unit
Burner control unit LMO 14.113A2 (cont.)
Diagnosis of fault causes
After a fault shutdown the red signal
lamp is constantly on. In this state,
the visual diagnosis of fault causes
can be activated in accordance with
Fault setting
on
(cont.)
the fault code table, by activating the
reset button > 3 s.
Fault setting
Visual diagnosis
flashing
Fault code table
Initial start−up, inspection and maintenance
The diagnosis of fault causes is
activated as follows:
reset
17