User Program Mode; Preliminary Information; Accessing User Program Mode - NAPCO Gemini GEM-P3200 Programming Instructions Manual

WI1184B 2/06

USER PROGRAM MODE

PRELIMINARY INFORMATION

The User Program Mode is covered in detail in the operating instructions for the keypad in use.
Only Keypad #1 may be used for programming, however this keypad may be located in any area.
The Program Mode cannot be accessed while the communicator is transmitting except during the first three minutes after
power-up.
After entering codes or data, press the save
If the keypad is in the Program Mode and no activity is detected for longer than 4 minutes, a steady tone will sound.
NOTE: For ease of programming, it is recommended that a GEM-RP1CAe2 or GEM-K1CA be used as Keypad #1. (A new GEM-
RP1CAe2/GEM-K1CA is automatically configured as Keypad #1). See Keypad Configuration Mode and WI818 for more information.
Press the C button to silence the sounder and exit the User Program Mode.
If a GEM-K2AS or GEM-RP2ASe2 keypad is used, configure address jumpers as Keypad #1 (see page 65, "Configuring the
Keypads"). Use the
R

ACCESSING USER PROGRAM MODE

1. Press EEEEEE
2. Press Q
3. Press P
4. Press C
L
NAPCO Security Systems
U
button. Data will not be stored into memory unless this button is pressed.
or button to manually scroll the display at the end of each programming line.
A
New Panel (Default User Code = 123)
Existing Panel (Any Code with User Program Option Enabled)
Until "TURNON PROG Y/N" (GEM-RP2ASe2/GEM-K2AS) or
"17" (GEM-RP3DGTL/GEM-K3DGTL or GEM-RP4RFC/
GEM-K4RF) appears on the LCD screen.
To Enter User Program Mode.
To Exit User Program Mode when finished.
R
X
GEM-P3200 Programming Instructions
Page 63