Direct Address Program Mode; Keypad Programming Overview; Accessing Direct Address Program Mode - NAPCO Gemini GEM-P3200 Programming Instructions Manual

Page 24

DIRECT ADDRESS PROGRAM MODE

This is an extension of the Dealer Program Mode. This method of programming is used in conjunction with the Keypad
Programming Worksheets that follow. Refer to these worksheets to identify the address locations of the features to be
programmed. Illustrative examples are provided on the next page.
DATA ENTRY
ADDRESS
LOCATIONS
LOCATIONS
LEFT DIGIT
3
0000
0000 HEXADECIMAL DATA:
TO •
BLANK (•) = No Options
4095
•
1 to 9 = Entries 1 to 9
•
0 = Entry of 10
•
B to F = Entries 11 to 15

ACCESSING DIRECT ADDRESS PROGRAM MODE

1. Press
EEEEEE
2. Press the PRIOR/NO (Q) button until:
"TURNON PROG Y/N" (GEM-RP2ASe2/GEM-K2AS)
"17" (GEM-RP3DGTL/GEM-K3DGTL or GEM-RP4RFC/GEM-
K4RF) appears on the keypad display.
3. Press the NEXT/YES (P) button to enter Dealer Program Mode.
(The panel and keypad version appears briefly on the keypad display).
4. Press C to exit Easy Menu Driven Program Mode & enter
Direct Address Program Mode.
(For keypad display examples when in Program Mode, see next page).
X
GEM-P3200 Programming Instructions

KEYPAD PROGRAMMING OVERVIEW

Direct Address Programming allows you to go directly to the
RIGHT DIGIT
address locations and change the data entries to customize your
C control panel options. Whereas the Easy Menu Program Mode is a
simple "quick start" guide with limited options, the Direct Address
Program Mode is more flexible, allowing you to change all the
options.
Master Security Code
(on microshield)
--or--
R
L
WI1184B 2/06
GEM-P3200
CONTROL
R
COMMUNCIATOR
MASTER SECURITY CODE
# - # - # - # - # - #
NAPCO Security Systems