Mac Clone - TP-Link TD-W8960N User Manual

TD-W8960N

Note:
ETH and ATM service can not coexist. If the ATM Interface had configured, you cannot configure
any other WAN service over the ETH Interface until the ATM Interface is deleted.
4.4.2.6 ETH-PPPoE
If your ISP provides a PPPoE connection and you need to use an ETH Interface, follow the steps
below to add a WAN service over a selected ETH interface:
1. Add a new ETH interface on the screen of
2. Click the Add button on the screen Figure 4-7 and the following configuration is similar to
PPPoE over ATM interface (see section
4.4.2.7 ETH-IPoE
If your ISP provides an IPoE connection and you want to use an ETH Interface, follow the steps
below to add a WAN service over a selected ETH interface:
1. Add a new ETH interface on the screen of
2. Click the Add button on the screen Figure 4-7 and the next configuration is similar to IPoE
over ATM interface (see section
4.4.2.8 ETH-Bridge
If you want to adopt the Bridge service and you need to use an ETH Interface, follow the steps
below to add a WAN service over a selected ETH interface:
1. Add a new ETH interface on the screen of
2. Click the Add button on the screen Figure 4-7 and the next configuration is similar to Bridge
over ATM interface (see section
4.4.3

MAC Clone

Choose menu "Advanced Setup""MAC Clone", you can configure the MAC address of the
WAN Interface as shown below.
The WAN Interface List displays the Lay2 Interfaces you have configured on the section
Layer2 Interface and its default MAC Address. If you have not configured corresponding WAN
Service for the interface on the section
"Need a corresponding WAN Service".
The last one of WAN Interface List displays your PC's current address.
300Mbps Wireless N ADSL2+ Modem Router User Guide
4.4.1.2 ETH
4.4.2.1 ATM-EoA-PPPoE).
4.4.1.2 ETH
4.4.2.2 ATM-EoA-IPoE).
4.4.1.2 ETH
4.4.2.3 ATM-EoA-Bridg).
4.4.2 WAN Service, the blank for MAC Address will display
Figure 4-20
27
Interface.
Interface.
Interface.
4.4.1