Mac Clone - TP-Link TL-WR850N User Manual

Chapter 4
1 ) Select the RADVD
to hosts.
Note:
Do not select the Enable RDNSS and Enable ULA Prefix check boxes unless required by your ISP. Otherwise
you may not be able to access the IPv6 network. For more information about RDNSS and ULA Prefix, contact
our technical support.
2 ) Keep Site Prefix Type
specific IPv6 site prefix, select
3 ) Keep WAN Connection
4. Click Save to make the settings effective.
4 3 3 2 Configure the DHCPv6 Server address type
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to Advanced >
3. Select IPv6 to configure IPv6 LAN parameters.
1 ) Select the DHCPv6 Server
addresses to hosts.
2 ) Specify the
generate IPv6 addresses within the specified range.
3 ) Keep Leased Time
4 ) Keep Site Prefix Type
specific IPv6 site prefix, select
5 ) Keep WAN Connection
4 3 4

MAC Clone

1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
address type to make the router assign IPv6 address prefixes
as the default value Delegated. If your ISP has provided a
Static
as the default value.
Network > LAN Settings
address type to make the router assign IPv6
Start/End IPv6 Address
as the default value.
as the default value Delegated. If your ISP has provided a
Static
as the default value.
Configure the Router in Wireless Router Mode
and enter the prefix.
page.
for the IPv6 suffixes. The router will
and enter the prefix.
22