HP StorageWorks 2000 Series Reference Manual page 52

You can configure network management services and in-band management services
to limit the ways in which users and host-based management applications can access
the system. If a service is disabled, it continues to run but cannot be accessed.
For information about permitting users to use enabled WBI, CLI, or FTP services,
see "Configuring User Access" on page 31.
For information about in-band management services, see "Configuring In-band
Management Services" on page 192.
To configure network management services:
1. Select Manage > General Config > Services Security.
2. In the Network Management Services panel, set these options:
Web Browser Interface (WBI) – SMU, the primary interface for managing the
system. You can enable use of HTTP, of HTTPS for increased security, or both.
The default is Enabled with HTTP and HTTPS.
Command Line Interface (CLI) – An advanced user interface for managing the
system. You can enable use of Telnet, of SSH (secure shell) for increased
security, or both. The default is Enabled with Telnet and SSH.
Storage Management Initiative Specification (SMIS) – Used for remote
management of the system through your network. The default is Enabled.
File Transfer Protocol (FTP) – Used as an alternative to the WBI for upgrading
system software. The default is Disabled.
Simple Network Management Protocol (SNMP) – Used for remote monitoring of
the system through your network. The default is Enabled.
3. Click Update Network Management Services.