HP StorageWorks 2000 Series Reference Manual page 283

90 Informational
95 Critical
96 Informational
100 Informational
101 Informational
103 Informational
104 Informational
105 Informational
106 Informational
The partner controller does not have a
mirrored configuration image for the
current controller, so the current
controller's local flash configuration
is being used. This event is expected
if the other controller is new or its
configuration has been cleared.
Both controllers in an active-active
configuration have the same serial
number. Non-unique serial numbers
can cause system problems; for
example, vdisk ownership and
WWNs are determined by serial
number.
Pending configuration changes that
take effect at startup were ignored
because customer data might be
present in cache.
During active-active operation, an
event (potential error) occurred while
communicating with the EMP, which
reports SES data.
An update of EMP data has been
triggered. This event is for internal
use only.
Volume name change is complete.
Volume size change is complete.
Volume LUN change is complete.
A volume has been added.
A service technician must examine
both controller serial numbers and
change at least one of them.
If the requested configuration
changes did not occur, make the
changes again and then use a user-
interface command to shut down or
restart the controller.