HP StorageWorks 2000 Series Reference Manual page 153

Topology – One of the following values:
Point-to-Point
Loop, if the loop is inactive
Private Loop, if the port is directly attached to a host
Public Loop, if the port is attached to a switch
To change this setting, see "Setting FC Host Port Topology" on page 42.
Speed – 2 Gbit/sec or 4 Gbit/sec. To change this setting, see "Setting FC Host
Port Link Speed" on page 40.
FC Address – 24-bit FC address, or Unavailable if the FC link is not active.
Loop ID – (Loop topology only) Current and requested loop ID values. To
change this setting, see "Setting FC Host Port Loop IDs" on page 40.
Node WWN – Controller module node World Wide Name.
Port WWN – Port World Wide Name.
The Host Port Status page shows a graphical representation of the host ports on each
controller, including a color-coded status for each port.
To display host port status information:
1. Select Monitor > Status > Advanced Settings > Host Port Status.
The status of each port is determined by the following color code:
Green – Host link is up (connected)
White – Host link is down (not connected)
2. To view information about a specific port, click the port.
The selected port is outlined in blue.