HP StorageWorks 2000 Series Reference Manual page 286

154 Informational
155 Informational
156 Informational
157 Critical
160 Warning
161 Informational
162 Warning
New software has been loaded on the
Management Controller.
New loader software has been loaded
on the Management Controller.
The Management Controller has been
restarted from the Storage Controller.
A failure occurred when trying to
write to the Storage Controller flash
chip.
The EMP enclosures are not
configured correctly. All enclosure
EMPs on that channel are disabled.
One or more enclosures do not have a
valid path to an EMP. All enclosure
EMPs are disabled.
The host Fibre Channel World Wide
Names (node and port) previously
presented by this controller module in
this system are unknown. This event
has two possible causes:
• One or both controller modules
have been replaced or moved while
the system was powered off.
• One or both controller modules
have had their flash configuration
cleared (this is where the
previously used WWNs are stored).
The controller module recovers from
this situation by generating a WWN
based on its own serial number.
Replace the controller module.
Check that EMP enclosures are
configured correctly and issue a
rescan.
Verify the WWN information for
this controller module on all hosts
that access it.