HP StorageWorks 2000 Series Reference Manual page 288

168 Warning or
informational
169 Informational
170 Informational
171 Informational
172 Warning
173 Informational
174 Informational
175 Informational
The specified SES alert condition was
detected in the enclosure indicated.
The specified SES alert condition has
been cleared in the enclosure
indicated.
The last rescan indicates that the
specified enclosure was added to the
system.
The last rescan indicates that the
specified enclosure was removed
from the system.
The specified vdisk has been
quarantined because not all of its
drives are available. There are not
enough drives to be fault tolerant.
The partial vdisk will be held in
quarantine until it becomes fault
tolerant.
The specified vdisk has been removed
from quarantine.
A device firmware update has
completed.
An Ethernet link has changed status
(up/down).
Most voltage and temperature
errors and warnings relate to the
power-and-cooling module.
See "Power-and-Cooling Module
Faults and Recommended Actions"
on page 302.
This event is generated when the
problem that caused event 168 is
cleared.
• Ensure that all drives are latched
into their slots and have power.
• During quarantine, the vdisk is
not visible to the host. If after
latching drives into their slot and
powering up the vdisk, the vdisk
is still quarantined, you can
manually remove the vdisk from
quarantine so that the host can
see the vdisk. The vdisk is still
critical.
When the vdisk has been removed
from quarantine, event 173 is
logged.