HP StorageWorks 2000 Series Reference Manual page 297

265 Informational
266 Informational
268 Informational
269 Informational
270 Warning
271 Informational
272 Informational
273 Informational
274 Informational
275 Informational
Port bypass circuits currently use the
service port, which may limit the link
speed or interconnect mode support.
A copy operation for the specified
master volume has been aborted.
A background copy operation for the
specified master volume completed.
A partner firmware update operation
has started. This operation is used to
copy firmware from one controller to
the other to bring both controllers up
to the same version of firmware.
There is a problem reading or writing
the persistent IP data from the FRU-
ID SEEPROM, or if invalid data is
read from the FRU-ID SEEPROM.
System could not get a valid serial
number from the controller's FRU-ID
SEEPROM, either because it couldn't
read the FRU-ID data, or because the
data on it isn't valid or hasn't been
programmed. Therefore, the MAC
address is derived by using the
controller's serial number from flash.
This event is only logged one time
during bootup.
The snap pool is being expanded.
Fault isolation has been enabled or
disabled for the specified enclosure
and controller within that enclosure.
A phy has been disabled.
A phy has been enabled.
Perform a system-level shutdown
and restart. Note that this will
cause all data to be unavailable for
about 1 minute.
Check the IP settings (including
iSCSI host channel IP data for an
iSCSI system), and update them if
they are incorrect.