Table of Contents
Advertisement
Using the EM 9046
74 |
Digital 9000
During the update, the following icon appears on the display panel
of your transmitter:
If the firmware update was successful, this icon disappears and
"Transmitter fw update
of the receiver's display panel.
If the update fails, the following icon appears on the display panel of
your transmitter:
In addition, the error message
briefly appears in the menu selection of the receiver's display panel.
In this case, place the infra-red interface of the transmitter in front
of the infra-red interface
mitter firmware without interrupting the infra-red transmission.
To read out and, if necessary, update the firmware of additional transmit-
ters:
Place the infra-red interface of the transmitters in front of the infra-red
D
interface
of the EM 9046, one after the other, and proceed as
described above.
To return to the main menu:
button L.
Press the
esc
successfull" appears in the menu selection
"Error: Transmitter fw update
D
of the EM 9046 and update the trans-
failed"
Advertisement
Table of Contents
