Table of Contents
Advertisement
Using the EM 9046
82 |
Digital 9000
After synchronization with the transmitter, the value actually adopted by
the transmitter is written back to the menu item.
"Display" – Selecting the standard display for the transmitters
frequency
The "Display" menu item allows you to activate one out of 3 standard dis-
plays: "Name", "Preset" or "Frequency". The "Name" standard display is
factory preset.
"Lock" – Activating/deactivating the lock mode
Via the "Lock" menu item, you can activate or deactivate the lock mode for
your transmitters.
"AF source" – Displaying the audio source
SK 9000 line
The
"AF
source" menu item allows you to display the type of microphone
head being used (SKM), the type of audio source being used (SK: "micro",
"line") and the emulation of instrument cables (SK: "type1", "type2",
"type3"). This information is transmitted along with the SKM/SK 9000's
RF signal to the receiver.
The information is displayed until the transmitter is switched off or the
carrier frequency is changed. When the SKM/SK transmits again on the
carrier frequency, the corresponding microphone head/audio source is dis-
played once again in the menu item.
If a transmitter is switched off or transmits on a different carrier fre-
quency,
"No TX
detected" is displayed.
"Cable" – Emulating different instrument cable lengths
type1
off
display
lock
af source
cable
Advertisement
Table of Contents
