Configuring The Pptp Client; Configuring The Pppoe Client; Figure 237 Internet Access Setup (Pptp); Table 166 New Fields In Menu 4 (Pptp) Screen - ZyXEL Communications ZyWALL 5 User Manual

Hide thumbs Also See for ZyWALL 5:

Table of Contents

29.3 Configuring the PPTP Client

Note: The ZyWALL supports only one PPTP server connection at any given time.

To configure a PPTP client, you must configure the My Login and Password fields for a PPP

connection and the PPTP parameters for a PPTP connection.

After configuring My Login and Password for PPP connection, press [SPACE BAR] and

then [ENTER] in the Encapsulation field in Menu 4 -Internet Access Setup to choose

PPTP as your encapsulation option. This brings up the following screen.

The following table contains instructions about the new fields when you choose PPTP in the

Encapsulation field in menu 4.

Encapsulation

Idle Timeout

If you enable PPPoE in menu 4, you will see the next screen. For more information on PPPoE,

Appendix D on page

Chapter 29 Internet Access

Menu 4 - Internet Access Setup

ISP's Name= WAN_1

Encapsulation= PPTP

Service Type= N/A

My Password= ********

Retype to Confirm= ********

Idle Timeout= 100

IP Address Assignment= Dynamic

IP Address= N/A

IP Subnet Mask= N/A

Gateway IP Address= N/A

Network Address Translation= SUA Only

Press ENTER to Confirm or ESC to Cancel:

Press [SPACE BAR] and then press [ENTER] to choose PPTP. The encapsulation

method influences your choices for the IP Address field.

This value specifies the time, in seconds, that elapses before the ZyWALL

automatically disconnects from the PPTP server.

ZyWALL 5 User's Guide