Installing The System Board - Dell PowerEdge R930 Owner's Manual

5. memory riser guide
Next steps
Install the system board.
Related Tasks
Removing the cable management tray
Removing a cooling fan
Removing a memory riser
Removing the memory riser and fan cage
Removing the fan tray
Removing a heat sink
Removing a processor blank and heat sink blank
Removing a processor
Removing an AC power supply unit
Removing the power supply unit bay
Removing the power distribution board
Removing the NDC riser
Removing the right expansion card riser
Removing the left expansion card riser
Removing an expansion card from expansion card risers
Removing the integrated storage controller card
Replacing the internal USB key
Removing the hard drive backplane
Removing the optical drive

Installing the system board

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be
performed only by Dell certified service technicians.
1. Ensure that you follow the
2. Unpack the new system board.
Steps
1. Holding the memory riser guide and metal bracket, lower the system board into the chassis.
CAUTION: Do not lift the system board by holding a memory module, processor, or other
components.
Safety instructions.
145