Removing The Ndc Riser - Dell PowerEdge R930 Owner's Manual

Removing the NDC riser

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you follow the
2. Follow the procedure listed in
3. Disconnect the cables connected to the Network Daughter Card (NDC) riser.
4. If installed, remove the left expansion card riser.
5. Locate the NDC riser (on PCIe slot 2).
Steps
1. Release the PCI retention rocker to unlock the NDC riser.
2. Hold the NDC riser by its edges, and pull the NDC riser till the card edge connector disengages from
the connector on the system board.
3. Lift the NDC riser away from the system.
Figure 34. Removing and installing the NDC riser
1. NDC
3. connector on the system board
98
Safety instructions.
Before working inside your system.
2. PCI retention rocker