Dell PowerEdge R930 Owner's Manual page 10

Item Indicator, Button, or
Connector
vFlash media card slot
1
2 Power-on indicator,
power button
3 NMI button
4 System identification
button
5 Video connector
6 LCD menu buttons
7 USB connectors (2)
8 Enterprise Service Tag
9 Hard drives (number of
drives will be either 4 or
10
Icon Description
Enables you to insert a vFlash media card.
The power-on indicator lights when the system
power is on. The power button controls the power
supply output to the system.
NOTE: On ACPI-compliant operating systems,
turning off the system using the power button
causes the system to perform a graceful
shutdown before power to the system is
turned off.
Used to troubleshoot software and device driver
errors when running certain operating systems.
This button can be pressed using the end of a
paper clip.
Use this button only if directed to do so by
qualified support personnel or by the operating
system documentation.
The identification buttons on the front and back
panels can be used to locate a particular system
within a rack. When one of these buttons is
pressed, the LCD panel on the front and the
system status indicator on the back flashes until
one of the buttons is pressed again.
Press the system identification button to turn the
system ID on or off.
If the system stops responding during POST, press
and hold the system ID button for more than five
seconds to enter BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup),
press and hold the button for more than 15
seconds.
Enables you to connect a VGA display to the
system.
Enables you to navigate the control panel LCD
menu.
Enables you to connect USB devices to the system.
The ports are USB 2.0-compliant.
A slide-out label panel, which allows you to record
system information such as Service Tag, NIC, MAC
address, and so on, as per your need.
2.5 inch hard drives