Updating From Download Mode - Datamax Iclass Operator's Manual

5.7.2 Updating from Download Mode

Application Version 2.08 (or less) Update Procedure*
Step Displayed Message
BOOT–PA10
1
02.08 2/11/00
UPDATE SOFTWARE
2
SEND SOFTWARE
UPDATE SOFTWARE
3
READING IMAGE
ERASING FLASH
4
SOFTWARE IMAGE
WRITING FLASH
5
SOFTWARE IMAGE
*This can also be used as an alternate method to download all other versions.
I-Class
Action
Turn OFF the printer.
Press and hold the PAUSE
Key and TEST Key while
turning ON the printer.
Using the DOS copy
command, copy the
filename to the printer
(see Section 5.7.1 for an
example).
No action required.
No action required.
No action required.
Comment(s)
The Boot Loader version is
displayed.
Note: This information will
vary with the printer model and
Boot Loader version.
The printer is ready to accept
the new application version.
Note: The parallel port
(LPT1) must be used to write
to the printer.
The printer is receiving the new
program.
Received and verified, memory
is now being cleared of the
previous program.
The new program is being
written into Flash memory.
Upon completion and after a
printer invoked reset, the new
application will run.
Note: If UNCALIBRATED is
displayed, see Section 5.2.
81